user manual

Tsunami MP.11 Installation and Management
Trap Groups
The user can enable or disable different types of traps in the system. By default, all traps are
enabled.
IP Access Table
Entries in this table show which wireless stations are allowed to use SNMP, HTTP, and telnet
management interfaces.
To add an entry, click Add; then specify the IP address and mask of the wireless stations to which
you want to grant access. For example, 172.17.23.0/255.255.255.0 allows access from all
wireless stations with an IP address in the 172.17.23.xxx range. Ensure that the wireless station
you use is the first entry in the table.
Trap Host Table
This table shows the SNMP management stations to which the MP.11 sends system traps.
5) Telnet
Click Configure Î Telnet to manage telnet parameters, including password and time out.
Note: To use HyperTerminal for CLI access, make sure to check “Send line ends with line feeds” in
the ASCII Setup window.
Chapter 5. Web Interface 43
CPN 63708 Issue Date: 02/05/2003