user manual

Tsunami MP.11 Installation and Management

Chapter 6. Command Line Interface

INTRODUCTION

The Command Line Interface (CLI) provides a text-based interface with which you can configure and

manage the MP.11 using commands. You can enter these commands or submit them in the form of

a script to allow batch processing. Accessing the CLI was previously discussed in “Command Line

Interface Overview” on page 21.

This chapter provides details about:

▪ Using Command Help below

▪ Viewing and Changing Parameters on page 61

Boot Loader Command Line Interface

The Boot Loader is started when the MP.11 is switched on or reset, and is responsible for starting the

embedded software. The Boot Loader CLI (which has only a limited set of commands) is available

when the MP.11 embedded software is not running.

USING COMMAND HELP

You can show CLI help by entering help at the command prompt. The CLI also provides context-

specific help. To provide help in a specific situation, enter ?. You can get help as follows:

? Lists all available commands.

s? Lists all commands beginning with an s.

set Shows the definition and a syntax example of the set command.

set ? Shows the parameter name of the set command that must be entered at the

position of the question mark. In this case you must enter a space before the ?. For

example:

download ?

download 10.0.0.2 ?

download 10.0.0.2 image.bin ?

<file_type (config/image/Boot Loader/license)>

download 10.0.0.2 image.bin image

set ip? Lists all parameters of the set command beginning with ip.

Note that the Boot Loader CLI does not have command help.

Chapter 6. Command Line Interface 60

CPN 63708 Issue Date: 02/05/2003