user manual

Tsunami MP.11 Installation and Management
CONFIGURATION RESTORE
You can restore the configuration of the MP.11 by downloading a configuration file. The configuration
file contains the configuration information of an MP.11.
To download a configuration file through the Web Interface:
1. Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2. Access the MP.11 as described in “Web Interface Overview” on page 20.
3. Click: Commands Æ Download.
4. Fill in the following details:
Server IP Address <IP address TFTP server>
File Name <configuration file name>
File Type Config
File Operation Download
5. Click OK to start the file transfer.
The MP.11 downloads the configuration file. The TFTP server program should show download activity
after a few seconds. When the download is complete and the system rebooted, the configuration is
restored.
CLI Configuration File Download
To download a configuration file:
1. Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2. Access the MP.11 as described in “Command Line Interface” on page 21.
3. Enter the following command:
download <IP address TFTP server> <configuration file name> config
The MP.11 downloads the configuration file. The TFTP server program should show download activity
after a few seconds. When the download is complete and the system rebooted, the configuration is
restored.
Chapter 7. Procedures 67
CPN 63708 Issue Date: 02/05/2003