Datasheet

6
Elektro-Feinwerkzeuge. Echte Einhandgeräte. Mit Gehäusekopf
aus Alu-Druckguss. Leise, präzise und effizient!
Design Patent
0
0
0
2
4
8
1
7
4
A
l
l
r
i
g
h
t
s
b
y
P
R
O
X
X
O
N
230
VOLT
3
2
1
This high-revving, special balanced, low noise DC motor has full-
wave electronic speed control. The ground steel spindle runs in a
ball bearing. Six high concentricity MICROMOT collets, (1 – 1.5 – 2 –
2.4 – 3 and 3.2mm and closure
nut) are included. Stable gear
head of die-cast aluminium
with 20mm MICROMOT collar
allows fitting of optional drill
stands and horizontal stands. Main housing of glass-fibre reinforced
POLYAMIDE. Supplied with 34 bits and cutters in a stable plastic
case.
Technical data :
230V. 5,000 – 22,000rpm. 100W. Length 230mm. Weight 500g. Insula-
ted to class 2.
NO 28 481
With 34 bits and cutters of industrial quality, all shafts
Ø 2.35mm. Complete with six triple slit steel collets covering
1 to 3.2mm (see page 24).
• For drilling, milling, grinding, polishing, cleaning,
cutting, carving, engraving and signing.
• For precision mechanics, model builders, jewellers,
opticians, artists and electronic enthusiasts.
Professional drill/grinder IBS/E
Precision electrical tools with even more power: The 2nd generation
of our tools with gear head made of die-cast aluminium.
Double-row ball bearing. Spindle of
ground steel with lock button for
rapid cutter changing.
Quiet, powerful 100W motor with
full wave electronics for speeds
between 5,000 and 22,000rpm.
Quality without compromise:
isolation according to class 2
requirements.
Streamlined head of die-cast aluminium for
exact bearing seats and optimal stability.
High concentric accuracy (maximum runout 3/100mm). No runout in your bits and cutters.
Note:
For any job on the workbench we recommend the
use of our mains-connected tools. They are light-weight,
easy to handle (shorter) and not limited
as to the time of operation.
1
3
All depicted tools are supplied in a storage case of high-grade
polypropylene. Attractive design, very sturdy and large enough to put
the machine back in the case after completing work, without having to
“fumble”. A label on the side identifies the contents.
2
Note:
MICROMOT steel collets are hardened and thus have a high, consistent
flexibility. They also maintain prolonged accuracy, even after regu-
lar use (these collets should not be compared with unhardened, four-
slit collets of brass and aluminium). The triple slit collet is substantially
more difficult to manufacture than the four-slit type,
but offers a better load- bearing surface.
This is especially important for
cutters with small shaft diameters.
Also see page 24.