Installation manual

PS Engineering
PMA6000 Series Audio Selector Panel and Intercom System
Installation Manual
200-066-0006 Appendix E Rev. 6, March 2005
Appendix E Top Connector wiring, (Stereo) PMA6000S, PMA6000MS, PMA6000MS-C
10
1
4
D
16
15
T
Notes:
1. All shields should be grounded at audio panel only.
other end remains floating.
2. All phone and mic jacks must be floating from ground.
3. All wiring to conform to MIL 22750 or 27500.
4. PMA6000 with serial number beginning with
"M" (on mono) or G (stereo) will have PTT intercom capability.
5. For units equipped with Internal Recorder System (IRS)
Use a Momentary NO switch to ground at pin 19.
6. Keyway bteween pins 4 and 5.
3
2
B
Copilot Phones (R)
Copilot Phones (L)
Copilot Phones Lo
Pilot Phones (L) -see bottom connector.
11
12
N
Pass. Phones (R)
Pass Phones (L)
Pass. Phones Lo
Pass. 1 Mic Jack
Pass. 1 Mic Lo
Pass. 1 Mic Hi
Pass. 1 Phones Jack
5
E
Pass. 2 Mic Jack
Pass. 2 Mic Lo
Pass. 2 Mic Hi
Pass. 2 Phones Jack
6
F
Pass. 3 Mic Jack
Pass. 3 Mic Lo
Pass. 3 Mic Hi
Pass. 3 Phones Jack
7
H
Pass. 4 Mic Jack
Pass. 4 Mic Lo
Pass. 4 Mic Hi
Pass. 4 Phones Jack
8
9
K
Copilot Mic Audio
Copilot Copilot PTT
Copilot Mic Lo
Copilot PTT
Copilot Mic Jack
Ent. #1 Audio (L)
Ent. #1 Audio (R)
Ent. #1 Audio Lo
Ent. #1 Input
Ent. #2 Input
14
13
R
Swap
Switch
Ent. #2 Audio (L)
Ent. #2 Audio (R)
Ent. #2 Audio Lo
Swap
PMA6000M-S-C TOP CONNECTOR (Stereo)
20
21
22
19
PASS ICS KEY
COPILOT ICS KEY
PILOT ICS KEY
See Note 4
IRS playback