user manual

158Record
• To record some more, tap REC or press Enter again. New
sound is added to the end of the existing recording.
• To start a new file, select the Create new file command
from the File menu. Type in the name before you begin
recording.
• To save your file under a different name, tap the Save as
button on the Toolbar or select the command from the File
menu.
• To replace the ending of an existing recording, use the pen
to drag the bar to the point where you want to begin
recording (or select the Go to time button or the
command from the Play menu and specify a start point in
minutes and seconds), then select the Record & replace
command from the Record menu.
• To erase the whole of the current recording, tap the Erase
button on the Toolbar or select the Erase all command
from the Record menu.
The maximum recording length depends on the amount of disk
space available. While recording, a ‘Time remaining’ indicator
shows how much more sound you could record if you wanted to
use the available space. Record will not allow you to completely
fill the disk, and will always leave 100K free so that you can use
other programs.
Note: If an alarm is due to ring while you are recording or playing
a sound, you may hear warning “ticks” and the alarm will be
postponed until you finish the current action.
Playing soundsPlaying sounds
Playing soundsPlaying sounds
Playing sounds
To play back the entire sound file, tap the PLAY button, press
the Spacebar, or select the command on the Play menu.
Note: The loudspeaker is located at the bottom of the machine,
next to the backup battery door.
• To play back only part of a sound, use the pen to drag the
cursor to the point where you want to begin playing (or
select the Go to time command from the Play menu and
enter the start position in minutes and seconds), then press
PLAY . Playback begins from the selected point. To pause
playback, press PLAY again.
• To adjust the volume, use the pen or the up and down
arrow keys to move the volume fader to one of the volume
settings, or set it to Min to turn off the sound completely.
• To play back a sound recording several times in succession,
tap the Repeat button or select the command from the
Tools menu and set the number of occurrences as
appropriate.