Instruction manual

OPERATING THE CONTROL INTERFACE SOFTWARE
Page 8 TMC-6700/ TMC-1000 Camera Control Software Manual
5.11 Write the Current Setting
The current setting can be saved as a file on the hard disk, or on the camera’s EEPROM.
5.11.1 Write the Current Setting into the Hard Disk as a File
Click on “File” and select “Save” from the menu bar. The
Save dialog window will appear. Type the file name you
want and save it. This allows you to save the current bank
setting as a file.
Note: If you select bank1 and save it as a file, only the
setting of the currently selected bank (in this case,
bank1) is saved. Other bank data will not be saved.
5.11.2 Write the Current Setting into the EEPROM
The current setting can also be saved by writing the setting
to the EEPROM. Click on “Write,” and select “EEPROM”
from the menu bar. Note that all bank data (from bank 1 to
4) is saved into EEPROM.
5.12 Read the Setting
A single bank setting can be restored from PC hard disk as a file. The setting can be read from one of
four banks of the camera’s internal RAM.
5.12.1 Read the Current Setting from the Hard Disk
The TMC-6700/TMC-1000 camera control software
allows you to restore a single bank setting from the file.
To load the setting, click on “File” and select “Open”
from the menu bar.
5.12.2 Read the Current Setting from
Memory Bank
You can read the setting from one of four banks of camera RAM memory space. Click on “Read” and
select “Bank Number (1 to 4)” from the menu bar.