Instruction manual

TROUBLESHOOTING AND FAQ
Page 10 TMC-6700/ TMC-1000 Camera Control Software Manual
In the “Manual” and “Async” group,
each category corresponds to a
shutter speed dial. To set your own
shutter speed value, enter them in the
text box directly. You may enter any
integer value from 0 to 1048.
You can also set the Direct Manual
shutter or the Direct Asynchronous
shutter value to any integer between
0 and 1048. These values are used
when you select “Direct M” or
“Direct A” from the shutter mode
combo box. See “Shutter Mode
Control” on page 4 for details on
selecting the shutter mode.
Note that the preset shutter value is
not necessarily equal to the number
(exposure time (H)) in Shutter Mode
Control Panel. TMC-6700/TMC-
1000 has its own conversion formula for exposure time calculation. Please contact PULNiX for details.
5.13.5 Initialize All RAM
Selecting “Initialize all RAM” enables you to restore all four RAM bank data from a file. Go to “Adv”
and select the “Initialize All RAM” option from the menu bar.
5.13.6 List all RAM Data
Selecting “List all RAM Data” enables you to save all four banks of parameter settings to a file. You
may use this file to inspect current RAM data or use it to to restore these settings into camera later on by
selecting “Initialize All RAM.”
6 TROUBLESHOOTING AND FAQ
Following are some troubleshooting suggestions for some common problems. If these suggestions do
not solve your problem, please see Section 6.2, “How to Contact Us,” on page 11.
6.1 PC and Camera Have no Communication
If the current communication port cannot be opened, check the following:
• Make sure the RS-232 cable is properly connected.