Instruction manual

SOFTWARE INSTALLATION
Page 2 TMC-6700/ TMC-1000 Camera Control Software Manual
3 SOFTWARE INSTALLATION
The TMC-6700/TMC-1000 camera can be operated from a PC
by using the PULNiX’s TMC-6700/TMC-1000 camera control
software. Instructions to install, use, and uninstall the software
follow.
3.1 Before Installing the Software
•
The TMC-6700/TMC-1000 camera control software
requires Microsoft Windows 95, 98, or NT 4.0.
•
It is recommended that you use small fonts for the Display
Properties dialog in the control panel.
•
The TMC-6700/TMC-1000 camera control software
requires one free serial communication port that is not in
conflict with other peripherals such as the mouse or modem.
•
Installation of the TMC-6700/TMC-1000 camera control
software requires 3.0 MB of hard disk space.
3.2 Installing the Software
To install the TMC-6700/TMC-1000 camera control software,
follow the steps below.
1.
Insert the installation diskette into the floppy drive of your PC and run “Setup.exe.”
2.
The installer will direct you to install the application code.
3.
Follow the installer instructions.
Note : You can change the installation directory if you want.
3.3 Uninstalling the Software
You can uninstall the TMC-6700/TMC-1000 camera
control software from either the control panel or the
taskbar. To uninstall from either location, follow the
steps below.
3.3.1 From the Control Panel
1.
Open “Add/Remove Programs” in the control
panel.
2.
Select “TMC1000” from the lists of the installed
software.