Instruction manual

OPERATING THE CONTROL INTERFACE SOFTWARE
Page 4 TMC-6700/ TMC-1000 Camera Control Software Manual
[HKEY_CURRENT_USER\Software\pulnix\TMC6700\TMC6700]
;Camera Type: TMC1000 or TMC6700
“Camera” = “TMC1000”
;Port Number: 1, 2 or 3
“PortNo”=dword:00000002
; BaudRate Setting (Write in hex)
“BaudRate”=dword:00004b00
3. Edit the “Port Number” value and “Baud Rate” value as your PC setting and save it.
4.
Close the Notepad and double-click the “tmc6700.reg” or “tmc1000.reg” file in Windows Explorer.
5.2 Comport Control
After you run the software, you need to open the current
communication port. Once the communication port is
opened, the camera name (TMC-1000 or TMC-6700) will
be displayed on the bottom of the software window. If this
information is different, refer to Section 6,
“TROUBLESHOOTING AND FAQ,” on page 10.
You can change the current comport while you are using the
software.
5.2.1 Open and Close the Current Comport
If you want to open or close the current comport, select “Comport” from the menu bar and then select
“Open” or “Close.”
5.2.2 Change the Comport
First, close the current comport. If you want to change the current comport, select “Comport” from the
menu bar and then select “Change.” The Comport Setting window will be opened. Change the comport
to whatever you like and click the “OK” button.
5.3 Shutter Mode Control
The Shutter Mode control allows you to specify Manual, Asynchronous,
or Direct shutter mode. The shutter speed selection settings for Manual
and Asynchronous modes are 0 to 9. For more detail regarding shutter
speed, please refer to the Operations Manual.