Instruction manual

Page 8
Configuring the TM-1327GE Camera
TM-1327GE Software
3 Configuring the TM-1327GE Camera
The configuration of your GigE camera consists of two parts:
• The imager configuration (CCD and control circuits)
• The internal frame grabber configuration
The imager can be configured for partial scan, binning, etc., just like a Camera Link camera. The
internal frame grabber is automatically configured for the pixel type, windowing, image size and I/O
and so on, by the GigE camera software.
3.1 Setup
If you have a peer-to-peer connection between the TM-1327GE camera and your PC without network
switches, your packet size can be the default value (8128 bytes) as shown in Figure 9. However, if you
are connecting the TM-1327GE to your PC through a network switch, then you need to know maximum
packet size that your network switch supports. Typically, if your switch supports jumbo packets, then
you should keep the packet size to 8128 bytes. If your switch does not support jumbo packets, then you
may need to change the packet size to 1440 bytes.
Figure 9. Camera Interface Application Dialog Box
Note If you connect
the camera through a
network switch, you
may need to modify
the packet size.