Instruction manual

Page 27
GigE Series Camera Serial Commands
TM-1327GE Software
Bit 7 TESTPATTERN 0=Disable TP; 1=Enable TP
Bit 6 Reserved System Flag
Bit 5
Bit 4 Reserved System Flag
Bit 3
Bit 2
Bit 1
Bit 0 Reserved System Flag
Byte 13 X1
(X1, Y1) Coordinate for Knee 1
(X1, Y1 = H’00 - H’FF)
Byte 14 Y1
Byte 15 X2
(X2, Y2) Coordinate for Knee 1
(X2, Y2 = H’00 - H’FF)
Byte 16 Y2
Byte 17 User Scan Start Point of User Scan Area
Byte 18 Active Line of
Scan
Active Line of User Scan Area
Byte 19 Direct Shutter H’000 - H’40F
Byte 20
Byte 21, 22
Byte 23, 24 Reserved Total line number H’040 - H’1F3
Table 5. 18 Bytes Status Report (Continued)