Instruction manual

Page 32
Installation
TM-1327GE Hardware
7.2 Camera Setup
7.2.1 Heat Dissipation
The TM-1327GE is a compact camera. Since all the electronics have been packed in a compact
package, the outer case of the camera can become hot because of heat dissipation. For optimal
performance, JAI PULNiX recommends using a cooling fan to set up a positive air flow around the
camera and following the precautions below.
• Mount the camera on a large heat sink (camera bracket) made out of a heat-conductive material like
aluminum.
• Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive
material like plastic.
• Make sure the camera has enough open space around it to facilitate the free flow of air.
Contact JAI PULNiX. at [phone] or send an E-mail to [e-mail] if you have any
questions.
7.2.2 Connector Pin Configurations
The TM-1327GE has a 12-pin Hirose connector for power input and signal integration as shown in
Figure 24.
Figure 24. 12-Pin Connector Pinouts
Pin #1 is Ground and pin #2 is +12V DC. Table 6 shows the pin-out table.
Table 6. 12-Pin Connector
The GigE socket, marked on the camera’s back panel as “GigE,” is a standard
RJ-45 Ethernet socket as shown in Figure 25.
Pin Description Pin Description
1 GND 7 VD in
2 +12V DC 8 Strobe
3 GND (analog) 9 HD in
4 Video out 10 Reserved
5 GND (digital) 11 Reserved
6 VINIT in 12 Reserved
1
2
3
4
5
6
9
8
7
11
12
10