Instruction manual

Page 34
Installation
TM-1327GE Hardware
JAI PULNiX Power Cables
If you are using JAI PULNiX power cables, such as the 12P-02S, refer to the Figure 26 which shows the
cable pin-out diagram and pinouts. The color-coded leads use Gray for Ground and Yellow for +12V.
Figure 26. 12P-02S Interface Cable (optional)
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed
wires could cause the leads to short.
Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Figure 26 on page 34. Connect the Ground lead to pin #1, and
the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient
current to properly power the camera.
Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. To properly attach the power cable to
the camera connector, use the following steps:
1. Rotate the connector while applying slight pressure until the keyways line up.
2. Press the connector into place until firmly seated.
3. Plug the power cord into the 100V AC socket. This powers up the camera.
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax TTL IN (EXT_VD)
2 Yellow +12V DC 8 White coax shield TTL OUT (STROBE)
3 Red coax shield AGND 9 White coax TTL IN (EXT_HD)
4 Red coax VIDEO 10 Brown RESV
5 Orange coax shield GND 11 Blue RESV
6 Orange coax TTL IN (EXT_TRIG) 12 Black coax shield RESV
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
Analog
Frame Grabber
GND (Gray)
}
Male