Datasheet

ML60.121
MiniLine
12V, 4.5A, SINGLE PHASE INPUT
INDEX
Page Page
1.
Intended Use .......................................................3
2. Installation Requirements...................................3
3. AC-Input...............................................................4
4. Input Inrush Current ...........................................5
5. Output .................................................................6
6. Hold-up Time.......................................................7
7. DC-Input...............................................................7
8. Efficiency and Power Losses................................8
9. Functional Diagram.............................................9
10. Front Side and User Elements.............................9
11. Terminals and Wiring........................................10
12. Reliability...........................................................10
13. EMC....................................................................11
14. Environment ......................................................12
15. Protection Features ...........................................12
16. Safety Features ..................................................13
17. Dielectric Strength ............................................13
18. Approvals...........................................................14
19. Fulfilled Standards ............................................14
20. Used Substances ............................................... 14
21. Physical Dimensions and Weight ..................... 15
22. Accessory........................................................... 16
23. Application Notes............................................. 17
23.1. Peak Current Capability ...........................17
23.2. Back-feeding Loads ..................................17
23.3. Charging of Batteries ...............................18
23.4. External Input Protection.........................18
23.5. Parallel Use to Increase Output Power....18
23.6. Parallel Use for Redundancy ....................19
23.7. Daisy Chaining of Outputs .......................19
23.8. Inductive and Capacitive Loads................19
23.9. Series Operation .......................................20
23.10. Operation on Two Phases ........................20
23.11. Use Without PE on the Input ...................20
23.12. Use in a Tightly Sealed Enclosure ............21
23.13. Mounting Orientations ............................22
The information presented in this document is believed to be accurate and reliable and may change without notice.
The housing is patent by PULS (US patent No US D442,923S).
No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.
TERMINOLOGY AND ABREVIATIONS
PE and symbol PE is the abbreviation for Protective Earth and has the same meaning as the symbol .
Earth, Ground This document uses the term “earth” which is the same as the U.S. term “ground”.
T.B.D. To be defined, value or description will follow later.
AC 230V A figure displayed with the AC or DC before the value represents a nominal voltage with
standard tolerances (usually ±15%) included.
E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
230Vac A figure with the unit (Vac) at the end is a momentary figure without any additional
tolerances included.
50Hz vs. 60Hz As long as not otherwise stated, AC 100V and AC 230V parameters are valid at 50Hz and AC
120V parameters are valid at 60Hz mains frequency.
may A key word indicating flexibility of choice with no implied preference.
shall A key word indicating a mandatory requirement.
should A key word indicating flexibility of choice with a strongly preferred implementation.
xxx. 201x / Rev. 1.1 DS--ML60.121-EN
All parameters are specified at 12V, 4.5A, 230Vac input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
2/22