Replacement Part List

MAINTENANCE
22
Storage
•
Remove any debris that has collected on the generator and around the muffler and controls. Use a vacuum cleaner to
pick up loose debris. If dirt is caked on, use a soft bristle brush.
• Inspect air cooling slots. Remove any debris if obstructed.
• Disconnect negative battery cable from battery.
• For short-term storage, start generator once every 7 days.
• For long-term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
• Store indoors and use a protective cover to protect from dust.
Draining the fuel tank
• Turn the engine OFF.
• Turn the fuel valve to the OFF position.
• Push the fuel valve knob through the valve holder bracket allowing you to access the petcock.
• When the fuel has drained from the tank, close the fuel valve and reinstall fuel line securely on petcock.
• Reinstall the fuel valve knob in the valve bracket. Push forward until knob snaps securely into position.
• Remove the fuel line that leads to the carburetor from the petcock by squeezing the ends of the hose clamps and
sliding the fuel line off.
Draining the carburetor
• Turn the engine OFF.
• Turn the fuel valve to the OFF position.
• Position a suitable container under the carburetor drain screw to catch fuel; loosen the screw.
• Allow fuel to drain completely into container.
• Retighten drain screw.
• If needed, install a fuel hose that will extend to a suitable fuel container large enough to catch the fuel being drained
from the tank.
• Turn the fuel valve to the ON position.
Consult your local hazardous waste management in your area for the proper way to dispose
of used fuel.
CAUTION!