Owner's manual

12
Step 1
Open the cover of the detergent reservoir by twisting it off.
Step 2
Fill the detergent reservoir with any approved liguid detergent.
Close the cover.
2000 PSI Pressure Washer
Step 3
Turn the adjustable nozzle to end of “LOW PRESSURE
SOAP”, put the pressure into
low-pressure mode.
Step 4
To apply the detergent to your work area. Turn the pressure washer switch
to the ON position. Pull the trigger to operate the unit. The pressure washer will mix
the detergent with water. Do not allow the detergent to dry on the object that you are
cleaning.
WARNING: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE
OR ANY OTHER CORROSIVE MATERIALS, INCLUDING LIQUIDS
CONTAINING SOLVENTS (I.E. GAS, OILS ETC), TRI-SODIUM
PHOSPHATE PRODUCTS, AMMONIA, OR ACID-BASED CLEANERS.
THESE CHEMICALS WILL HARM THE UNIT AND CAUSE DAMAGE
TO THE SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
Step 5
To clean the working srea, turn the adjustable nozzle to end of “HIGH PRESSURE”,
return it to high-pressure mode. Spray high-pressure water onto the work area to rinse
off the work area and any remaining detergent.
Low Pressure Setting