Owner's manual

TROUBLESHOOTING TIPS

2000 PSI Pressure Washer

Electrical socket is faulty Check plug, socket, and fuses

Voltage is inadequate Check that the voltage is adequate

GFCI trips Reset / Try another outlet

Power cord is not plugged in Plug in power cord

Water Intake Filter is clogged Remove and clean filter

Pump is drawing air Tighten connections/bleed system

Suction valves are clogged/worn Clean or replace valves

Diameter of garden hose too small Replace to 1” inch garden hose

Water supply is restricted Check hose for kinks or leaks

Insufficient water supply Fully open the water source

Excessive air in waterline and pump T

bleed lines

urn unit and water supply off / and

Intake is blocked Check the intake valves

Valves are worn, dirty, or clogged Check, clean or replace valves

Water Intake Filter is dirty Check, clean, or replace filter

Net voltage lower than suggested C

adequate

heck to determine that the voltage is

WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START

PROBABLE CAUSE

SOLUTION

PROBABLE CAUSE SOLUTION

THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES

THE PRESSURE WASHER HAS OR WILL NOT MAINTAIN PRESSURE

THE PRESSURE WASHER MAKES EXCESSIVE NOISE

THE MOTOR STOPS RUNNING WHILE IN USE