Use and Care Manual

12
Step 1
Open the cover of the detergent reservoir by twisting it off.
Step 2
Fill the detergent reservoir with any approved liguid detergent.
Close the cover.
2000 PSI Pressure Washer
Step 3
Turn the adjustable nozzle to end of “LOW PRESSURE
SOAP”, put the pressure into
low-pressure mode.
Step 4
To apply the detergent to your work area. Turn the pressure washer switch
to the ON position. Pull the trigger to operate the unit. The pressure washer will mix
the detergent with water. Do not allow the detergent to dry on the object that you are
cleaning.
WARNING: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE
OR ANY OTHER CORROSIVE MATERIALS, INCL
UDING LIQUIDS
CONTAINING SOLVENTS (I.E. GAS, OILS ETC), TRI-SODIUM
PHOSPHATE PRODUCTS, AMMONIA, OR ACID-BASED CLEANERS.
THESE CHEMICALS WILL HARM THE UNIT AND CAUSE DAMAGE
TO THE SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
Step 5
To clean the working srea, turn the adjustable nozzle to end of “HIGH PRESSURE”,
return it to high-pressure mode. Spray high-pressure water onto the work area to rinse
off the work area and any remaining detergent.
Low Pressure Setting
13
2000 PSI Pressure Washer
High Pressure Setting
CLEAN-UP AND STORAGE
Shutting Down the Pressure Washer
WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE
STEPS TO SHUT DOWN THE UNIT:
Ь Turn the pressure washer to the OFF position.
Ь Turn off the water supply.
Ь Before disconnecting high-pressure hose connection, point the gun in a
safe direction and discharge the high-pressure water.
Ь Disconnect high-pressure hose from the pressure washer and gun.
Ь Disconnect garden hose from the pressure washer.
Ь Remove excess water from the pump by tipping the unit on both sides to
drain any remaining water from the inlet and outlet fittings.
Ь Remove the Water Intake Filter and flush with water to remove dirt or
debris. Return the filter once it is cleaned.