Use and Care Manual

16
Cars, Boats, and Motorcycles
Rinse the area with fresh water. If using detergent, fill the detergent reservoir and apply
to the area being cleaned at low pressure. To achieve the best results, clean one side
at a time. Allow the detergent to remain on the surface for a few minutes, but do not
let the detergent dry. Rinse at high pressure using the fan spray in a sweeping motion
keeping the tip of the spray nozzle at least 8 inches from the cleaning surface. Maintain
2000 PSI Pressure Washer
a greater distance from the cleaning area when using a direct spray.Wipe the surface
dry for a polished finish.
Barbecue Grills, Power Equipment, and Garden Tools
Rinse the area with fresh water. If using detergent, fill the detergent reservoir and apply
to the area being cleaned at low pressure. Allow the detergent to remain on the surface
for a few minutes, but do not let the detergent dry. Rinse at high pressure using the fan
spray keeping the tip of the spray nozzle at least 1-3 inches from the cleaning surface.
Maintain a greater distance from the cleaning area when using a direct spray.
TECHNICAL DATA
WARRANTY
R
guarantte.
efer to the enclosed warranty regarding conditions for the terms and conditions of
ENVIRONMENT
Should your machine need replacement after extended use, please do not dispose with
regular wash but dispose of it in an environmentally safe way.
Main voltage 120 V
Main frequency 60 Hz
Max. operating pressure 2000PSI
Water consumption 1.6 GPM
Max. pressure water supply 40-80PSI
Max. water temperature 40-140F(5-60°C)
Weight 26LBS
17
TROUBLESHOOTING TIPS
2000 PSI Pressure Washer
Electrical socket is faulty Check plug, socket, and fuses
Voltage is inadequate Check that the voltage is adequate
GFCI trips Reset / Try another outlet
Powercordisnotpluggedin Pluginpowercord
Water Intake Filter is clogged Remove and clean filter
Pump is drawing air Tighten connections/bleed system
Suction valves are clogged/worn Clean or replace valves
Diameter of garden hose too small Replace to 1” inch garden hose
Water supply is restricted Check hose for kinks or leaks
Insufficient water supply Fully open the water source
Excessive air in waterline and pump T
bleed lines
urn unit and water supply off / and
Intake is blocked Check the intake valves
Valves are worn, dirty, or clogged Check, clean or replace valves
Water Intake Filter is dirty Check, clean, or replace filter
Net voltage lower than suggested C
adequate
heck to determine that the voltage is
WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START
PROBABLE CAUSE
SOLUTION
PROBABLE CAUSE SOLUTION
PROBABLE CAUSE SOLUTION
PROBABLE CAUSE SOLUTION
PROBABLE CAUSE SOLUTION
THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES
THE PRESSURE WASHER HAS OR WILL NOT MAINTAIN PRESSURE
THE PRESSURE WASHER MAKES EXCESSIVE NOISE
THE MOTOR STOPS RUNNING WHILE IN USE