Instructions / Assembly

3Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Safety and Warnings
User weight more than 50lbs may damage the scooter.
Be sure the rider keeps both hands on the handlebars and stand on
the center of the deck at all times while riding.
Only use the battery specied by the manufacturer.
Only use the charger specied by the manufacturer.
Check and obey any local laws or regulations which may affect the
locations where the electric scooter may be used.
Do not activate the go button unless you are on the scooter and in a
safe environment that is suitable for riding.
Do not attempt or perform stunts or tricks on this electric scooter. This
product is not made to withstand abuse from jumping, curb grinding or
any other type of misuse or stunts.
Never allow more than one person at a time to ride the scooter.
Never use near steps, water, or swimming pools.
Never ride while using a cell phone or wearing headphones.
Never hitch on to or with another vehicle or pull anyone or anything.
Never immerse the scooter in water; electrical and drive components
could be damaged by water or create other possible unsafe
conditions.
Ride only on at, dry surfaces such as pavement or level ground
without loose debris, such as sand, leaves, rocks or gravel. Water,
mud, ice, bumpy, uneven, slick, or rough surfaces could impair traction
and contribute to possible loss of control. Avoid excessive speeds that
can occur from downhill rides which could cause loss of control.
Do not ride at night or in areas of limited visibility.
Before each ride the following checks will need to be performed
to the scooter:
• That all components are properly secured and are functioning
according to manufactures specications.
• Components shall be maintained and repaired in accordance with
the manufacturers authorized replacement parts with installation
performed by dealers or other skilled individuals.
USING THE BATTERY CHARGER
The battery charger should be regularly examined for damage to the
cord, plug, enclosure and other parts. In the event of such damage,
if any is found, the scooter should not be charged until the battery
charger has been repaired or replaced.
Use only with the supplied recommended battery charger.
Always use caution when charging.
The battery charger is not a toy and should be operated by an adult.
Never operate battery charger near ammable materials or liquids.
Disconnect the battery charger and unplug from scooter
when not in use.
Do not exceed recommended charging time.
Always disconnect the battery charger from the scooter prior
to wiping down and cleaning with any liquid.
FAILURE TO HEED TO THE WARNINGS LISTED ABOVE
INCREASES RISK OF POTENTIAL SERIOUS INJURY.
USE THE APPROPRIATE CAUTION WHEN RIDING AND
ALWAYS WEAR PROTECTIVE GEAR.
THERMAL FUSE
This product is equipped with a built in thermal fuse that
will activate if the motor is overloaded. This self-resetting
fuse will automatically reduce power to the motor when it
becomes overloaded. Overloading of the fuse can occur
from any one or a combination of the following:
• Rider exceeds the maximum weight limit
• Riding up steep inclines
• Running into xed Objects
• Pulling or towing anything behind the scooter
WARNING: Any changes or modications to this
unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.