Instructions / Assembly

7Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Hardware Maintenance
Before You Ride
Riding
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is possible for aggressive rider to run into a curb or wall and bend or
break a frame. Get in the habit of inspecting your scooter on a regular basis.
Tires
Periodically inspect the wheels for excess wear.
Safety Gear
Always wear proper protective gear such as an approved safety helmet. Elbow pads and knee pads are recommended. Always wear athletic
shoes (lace up shoes with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels, motor
and drive system.
Battery
Never store the product in freezing or below freezing temperatures! Freezing will permanently damage the battery.
Before you ride always check and for the following:
Safety Gear
Always wear proper protective gear such as:
• Approved safety helmet. (Helmet may be legally required by local law or regulation in your area.)
• Elbow pads and knees pads
• Long sleeved shirt, long pants
• Gloves
• Lace up shoes with rubber soles.
Go Button
Make sure that before Go Button is pressed that you are in an open and safe area to ride, you are balanced on the scooter and have both hands
on the handlebar controls. Press Go Button to engage motor, release Go button to stop.
WARNING: Always ensure that you are in a safe open area to ride before you press the Go Button. Never
press the Go Button without being on the scooter in a balanced, ready to ride position with both hands on the
handlebars; once the button is pressed the scooter will move.
Failure to follow these instructions may damage your scooter and void your warranty.