Installation & Assembly

Installation Instructions

Insert wall anchors (10) until ush with wall. Slide top mount (7) over

slide bar.

Mark wall for two mounting holes. Before drilling ensure no live plumbing

can be damaged. Slowly drill 1/4" (6mm) wide by 1" (25mm) deep holes

5/8

inches (575mm) apart.

IMPORTANT: Supplied anchors are for solid surfaces only i.e. tiles, marble,

etc. If mounting to hollow or berglass wall, a dierent anchor/screw and

hole size may be required.

Use screw driver to secure screw (8).

Align tab on soap dish with slot on sleeve and push soap dish down until ush.

Slide lower mount (7) over slide bar and secure set screw (8).

Press covers (9) onto mounts (7).

Slide ABS soap dish (12) onto slide bar followed by narrow end of tapered

nylon sleeve (11).

CAUTION: Live Plumbing