Installation Guide

Installation
Setting Maximum Water Temperature Preset
NOTE— This valve includes a factory maximum water temperature preset known as a
limit stop.
WARNING: Failure to adjust the limit stop properly may result in serious scalding.
This shower may not protect the user from scalding where there is a failure of other
temperature controlling devices elsewhere in the system.
1. Loosen set screw (15) with an allen wrench and remove valve handle (14).
2. Remove cartridge trim nut (13) and trim sleeve (12) by hand.
3. For a lower temperature, pull red limit stop (10) out with needle-nose pliers, turn it
counter-clockwise and push it back onto cartridge.
4. For a higher temperature, pull red limit stop (10) out with needle-nose pliers, turn it
clockwise and push it back onto cartridge.
5. Reinstall cartridge trim sleeve (12), trim nut (13), and valve handle (14).
Tighten set screw (15) with an allen wrench.