Installation Manual

5
Installation Instructions
1/2”
Step 1
Step 2
1/2”
Step 1
Step 2
Step 1
Step 2
1
2
Step 1: Apply plumber's tape to the nipple (1). Step 2: Screw
nipple (1) into pipe making sure you have 1/2" extending
beyond nished wall surface. NOTE: If supplied 2" nipple (1)
is not correct length you must obtain correct size NPT brass
nipple (sold separately), available at most hardware stores.
Step 1: Apply plumber's tape to the nipple (1). Step 2: Screw
inlet tting (2) onto nipple (1).
Use at part of inlet tting, as shown, to secure
inlet onto nipple.
TIP
Back Top T
Step 1
Step 2
1/2”
Step 1
Step 2
Step 1
Step 2
4
5
Slide soap dish (11) onto shower bar (7) from top.
Remove set screws (4) from the sides of Top T (5).
Step 1: Loosen set screws (4) slightly. Step 2: Connect Top T
(5) to shower bar (7) and secure with set screw (4).
3