Owner Manual

Assembly

After unpacking your ShowerSpa, some assembly is required prior to installation.

Shower Arm Assembly

Attach shower arm to the shower arm base and secure.

Handshower Holder Assembly

NOTE— The handshower holder is directional and must be installed so the set screw is facing down in order for the tapered end of the

hose to t properly.

1. Use 4mm allen wrench to remove allen bolt from handshower holder and retain lock washer. Insert bolt through lock washer,

then opening on side of ShowerSpa. Tighten bolt to holder while adjusting its’ position (we recommend a slight forward angle).

2. Secure set screw on bottom side of holder to lock in place.

After ShowerSpa is mounted to the wall

Handshower Assembly

1. Insert washer (5) into hexagon shaped end of handshower hose (6) and attach to threaded outlet on bottom of ShowerSpa.

Do not over-tighten.

2. Insert washer (5) into tapered end of handshower hose (6) and attach to handshower (7). Insert handshower (7) into hanger.

3. Check that rubber screen washer (5) is in showerhead (4) and screw showerhead onto the shower arm (2).