Product Manual
10
10
:
:TROUBLE SHOOTING:
CONDITION CAUSE CORRECTIVE
Compressor won’t
start
1:Loose electrical connection
2:Motor overheated
1:Check wiring connection
2:Press reset button or wait for
automatic reset
Low pressure
1:Malfunction in valves
2:Loose tube of fittings
3:Restricted air filter
4:Defective check valve
1:Check inlet and exhaust valves
2:Tighten fittings
3:Clean or replace filter
4:Replace check valve
Pressure relief valve
releasing
1:Defect pressure switch or
improper adjustment
2:Defective pressure relief valve
1:Check for proper adjustment and
if problem persists replace
pressure switch
2:Replace valve
Excessive dust
formation or
appearance of water
1:Restricted air intake filter
2:Worn valves
3:Worn piston rings
4:High ambient temperature
and / or humidity
5:Over usage of this compressor
1:Clean or replace filter
2:Replace valve assembly
3:Replace piston ring
4:Install a moisture separator
and/or dryer
5:Check for air leakage. If no leaks
are found, bigger compressor
is needed.
Water in air receiver
tank
1:Condensation in the air
receiver。
1:Drain daily or install an automatic
drain。
Excessive noise
1:Loose valves
2:Loose piping
3:Unit not installed level
4:Carbon or foreign material on
piston
5:Worn bearings
1:Inspect valve for damage
2 : Tighten as required
3:Ensure that unit is mounted level
4:Clean piston
Check cylinder walls for scoring
5:Replace bearings