Product Manual

7
5-2-3-1：This pressure switch control the on/off of the compressor, it can be turn off manually but
when it is in the AUTO position, it allows the compressor to start or shut down
automatically without warning upon air demand. Always set this switch to OFF when
the compressor is not in use and before unplugging compressor.
5-2-4：AIR PRESSURE REGULATOR
The air pressure regulator allows operator to adjust line pressure for the tool in use.
Never exceed maximum working pressure of the tool. To adjust, pull up the knob, turn
clockwise to increase pressure or turn counterclockwise to decrease pressure.
5-2-5：GROUNDING INSTRUCTIONS
Do not modify the plug that has been provided, if it does not fit the available outlet, the
correct outlet should be installed by a qualified electrician. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes. If these
grounding instructions are not completely understand or if in doubt as to whether the
compressor is properly grounded, have the installation checked by a qualified electrician.
5-2-5-1
：
：This product is for use on a nominal 115 or 230 volt circuit. A cord with a grounding plug
as shown here shall be used. Make sure that the product is connected to an outlet that
matches the plug. No adapter should be used with this product.
(FOR AREA OTHER THAN USA, PLEASE CHECK THE LOCAL CODE.)
5-2-6：EXTENSION CORDS
The use of any extension cord will cause some drop in voltage and loss of power. For
optimum performance, plug the compressor power cord directly into a grounded wall socket.
Do not use an extension cord unless absolutely necessary. It is better to use a long air hose
to reach area where work is being performance. If use of an extension cord can not be
avoided, refer to the following guidelines ：
Use only 3-wire extension cord. Make sure your extension cord is in good condition. Be
sure gauge is sufficient to carry the current the unit will draw. Note that the smaller the
gauge the heavier the cord. Example: Gauge 10 is heavier than gauge 12.