Installation Guide

18
MODEL# 9414TS - ENCLOSURE
ENCLOSURE ASSEMBLY INSTRUCTIONS
B
A
C
D
E
STEP 4:
Place the Enclosure Net (Part 9) on top of
the trampoline. Align the straps to the
corresponding Enclosure Poles so they are
as near to each other as possible when
lifted.
NOTE:
Make sure that zipper and buckle snap are
facing the outside of the trampoline. This is
good to ensure that Enclosure is not
reversed.
STEP 5:
Use the Black String (Part 8) to attach the
Enclosure Net to the Jump Mat. by sliding
the string through the hole in the net then
looping through the nearest V-Ring slot,
and hook to an adjacent V-Ring as shown.
Repeat this until ends meet then tie in a
knot securely on each V-Ring.
Step 6:
A. Locate the top of the enclosure netting
loops with snaps.
B. Detach the snaps by pushing on the
middle of the buckle.
C. You can adjust straps on buckle as
needed.
D. Once strap length is adjusted loop
through enclosure pole cap and fasten.
E.
Snap closed