User Manual
www.PyleUSA.com
11
1. Connect the Lan port (RJ45) of the tv and the router using a an cable. The router should be connected
to the Internet beforehand.
• If the router supports DHCP, the tv is automatically connected to the network when you connect the
tv to the network with a Lan cable.
If the network is not automatically connected
2. Press the button on the remote control.
3. Selected connection network connection settings wired connection (Ethernet).
To see the details, click the settings connection network connection settings in user guide.
WIRELESS NETWORK SETTING
1. Turn ON the power of the router connected to the internet.
2. Press the button on the remote control.
3. Select connection network connection settings wi- connection.
4. When the network search is complete, the list of networks available for connection is shown.
5. Select a network to connect.
6. If your wireless Lan router is password protected, enter the password congured for the router.
To see the details, click the settings connection network connection settings in user guide.
NETWORK SETTING WARNINGS
• Use standard Lan cable (connect to cat7 or higher with RJ45 connector, 10 base-T, or 100 base Tx Lan port)
• Resetting the modem may x some network connection problems. Turn the power OFF, disconnect and
reconnect it, and then turn the power on to solve the problem.
• The manufacturer is not responsible for any network connection problems or any faults, malfunctions,
or errors caused by network connection.
• The network connection may not work properly because of network settings or the Internet Service
Provider.
• DSL service must use a DSL modem; and cable service must use a cable modem. Since only a limited
number of network connections may be available, TV network setting may not be used depending on
the contract with Internet Service Provider. (If the contract does not allow more than one device per line,
only the already-connected PC may be used.)