Operating instructions

Page 4
Unpacking
Keep your packaging for use if your AC receiver is stored for a time or
needs to be returned for whatever reason. The packaging should contain:-
• Your PY-ACW, AC receiver with PS1 or PS5 (24V AC)
• An A4 Module Description sheet (for installation details)
• These Instructions
• Two identical bar-codes
Check the product code on the serial number label. If you have an
incorrect item or it is damaged then inform the suppliers and carriers
immediately. If this is the case then do not attempt to use your AC
receiver.
These Instructions
These instructions allow you to install your Pyramid AC receiver, they
do not contain any application information. As the installer you are
assumed to have a sound knowledge of how AC receivers operate, if you
have not then contact a CCTV installation company for advice.
If you are replacing a receiver on a network which is already operational
then see Manual 1 - Operating Instructions for instructions on connecting
a new receiver using the keyboard.
The connection diagram is shown on the next page. Using this follow the
instructions. The instructions are listed by connector and describe wiring
your AC receiver to the P/T head, the lens, the network and the power
supply.
At the end of the connections section is a description of the on-board test
routine, once the tests are complete and all the connections are correct
your AC receiver needs no maintenance.
Bar Coding
All the pyramid modules are supplied with two identical bar-codes,
remove one and affix it to the module description sheet, remove the other
and affix it to the module.
The bar code gives the unique 48-bit module address. Make a careful
note on your module description sheet of all your installation details and
the location of the module. Then during subsequent installation using the
Windows™ installation tool the module address can be entered (using a
bar code reader) with the description.