QUICK START GUIDE [ Quick Start Guide ] FIBRE CHANNEL SWITCH INSTALLATION SANbox 3810 for Windows® Operating Systems z
Quick Start Guide Installation Instructions Congratulations on your purchase of the SANbox® 3810 Fibre Channel Switch. This guide describes the steps to install and activate your new switch using a Windows® workstation. For advanced options and instructions (including Solaris®, Linux®, and Mac OS X® installations), refer to the SANbox 3810 Fibre Channel Switch Installation Guide, which is available at www.qlogic.com. NOTE: Do not apply power to the switch until instructed in Step 4. Step 1.
Step 5. Verify Workstation Requirements ❑ ❑ Verify that your workstation can support the QuickTools™ application with the following minimum requirements: ❑ Windows® 2003 and XP SP1/SP2 ❑ 512 MB memory minimum; 1 GB recommended ❑ 1 GHz processor ❑ Video card with 256 colors ❑ RJ-45 Ethernet port ❑ Internet Browser: Microsoft® Internet Explorer® 6.0 and later, Netscape Navigator® 6.0 and later, Firefox® 1.5 and later, or Mozilla™ 1.5 The default IP address of a new switch is 10.0.0.1.
Please feel free to contact your QLogic approved reseller or QLogic Technical Support at any phase of integration for assistance. QLogic Technical Support can be reached by the following methods: Web: http://support.qlogic.com E-mail: support@qlogic.com The QLogic knowledge database contains troubleshooting information for the QLogic HBAs. Access the data base from the QLogic Support Web page, http://support.qlogic.com. Use the Support Center search engine to look for specific troubleshooting information.
