User's Manual

2 – Operations and Administration

Configuration and Monitoring Features

2-52 D000003-006 Rev. A

4. Click Apply.

NOTE:A reboot is required to activate the new gateway IP address.

2.2.13

Fabric Manager Configuration

NOTE: This section assumes the user has purchased and activated the

embedded version of the Fabric Manager

NOTE: For the SilverStorm 9020, the Fabric Manager Configuration submenu is

part of the EVIC and FVIC menu.

Figure 2-76. Subnet Manager Submenu

2.2.13.1

Automatically starting the Fabric Manager

To enable the Fabric Manager to automatically start at boot time:

1. From the menu, click Subnet Manager.

2. Click Configuration. The Subnet Manager Configuration window is displayed:

Subnet Manager Configuration Window

Figure 2-77. Subnet Manager Configuration Window

3. To configure the Fabric Manager to automatically start with each boot, click

Enabled.

NOTE: If the user wants to manually activate the Fabric Manager, click Disabled.

4. For MPFD 9080, 9120 and 9240 switches, in a redundant management

configuration, the Start On Slave option should be set to Disabled. In the event

that the Fabric Manager on the master spine is disabled, the Fabric Manager