Owner's Manual

QL-K1001
GM Full Size Pickup 1988-1994
GM Suburban/Blazer 1992-1994
Remove Original Kick Panel
• Remove threshold plate by removing attachment screws.
• Pull kick panel away from bulkhead to release mounting clips.
• Make sure all mounting clips are removed.
• Tilt bottom front edge upward and pull kick panel out of vehicle.
Modify Parking Brake Pedal
• Using two crescent wrenches, carefully bend brake pedal arm so that
pedal pad is relocated approximately 1.5 inches to the right.
NOTE: Always check the fit of the Q-forms into the vehicle before any cutting or
modifications are done.
Install Speakers␣ ␣
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the
vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of
speaker mounting surface. A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into
mounting surface. Be careful to center speakers in mounting surface to allow clearance
for grill shell.
• Install tweeters as per manufacturer’s instructions.
Install New Q-Forms Kick Panels (Always predrill all mounting screw locations)
• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original
kick panel. Be sure front edge of panel fits tightly against rubber door seal.
• Reinstall threshold plate using original screws. It may be helpful to hold panel
tightly against rubber door seal while tightening front screw.
• Install long screw and spacer through hole at rear of panel and drive into
inner bulkhead sheetmetal. It may be helpful to predrill screw pilot hole if
installed without power tools.
• Install grill shells by pressing snugly into woofer cavity.
QL-K1001 Included Hardware:
(2) 2.5" plastic spacers
(2) 3" screws
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
Estimated Installation Time: 1.5 Hrs.Estimated Installation Time: 1.5 Hrs.
Estimated Installation Time: 1.5 Hrs.Estimated Installation Time: 1.5 Hrs.
Estimated Installation Time: 1.5 Hrs.
inst ver 23.1