User manual

QSTD5304 Digital Video Recorder User Manual
24
1. NET SERVER
If you select the check box and set the port number of the server, you will
enable the NET SERVER.
2. NET VIDEO QUALITY
This refers to the picture quality in remote surveillance. There are three
options: low, medium and high. The higher of the quality value, the clearer
the image is, the lower the quality value, the less bandwidth the video takes
up. The default level is medium.
IP CONFIGURATION
IP Configuration submenu is shown as Fig. 3.20.
This is the DVR’s IP configuration. There are three options: STATIC, DHCP
and PPPoE.
If you use the Static IP address option you will need to access the router the
DVR is attached and get the setup information. You can do this by going to
the run option on a computer that is attached to the same router as the DVR
and typing cmd or command to get to a command prompt. At the command
prompt type ipconfig and hit ENTER to access the network information. The
screen will list the computer’s IP address, the Subnet Mask, and the Gateway.
The IP address you assign to the DVR must have the same first 3 sets of
numbers as the Gateway. If the computer’s IP address ends in a 1 or 2 digit
number you can select an IP address ending in 100, if the computer’s IP
address ends in a number in the 100s then select an IP address ending in
200.
Fig 3.20 IP Configuration
Fig 3.21 System Information