- Digital Peripheral Solutions Speaker System User Manual

Operation

Using By Connecting with Bluetooth AV Dongle

1. Press & Hold the Speaker Pairing Button for 8 Seconds until LED alternately

Flashes Red & Blue

2. Press & Hold the Dongle (Base) Pairing button for 8 seconds until LED

alternately Flashes Red & Blue

3. After steps 1 & 2 are completed - wait 3 - 5 seconds - LEDs on Speaker & Base

will Flash Blue to Confirm Pairing

4. Plug the 3.5mm Phone Jack on the Base into the Headphone Jack on your Audio

Device, then Press PLAY

Remark:

Initial Set Up should only required for first time use. If you change devices - then you will

need to repeat steps 1 – 3

Dongle & Speaker will exist the pairing mode after 1 minute if the pairing fails. To return the pairing

mode, turn off the device and restart step 1 - 2).Passcode of this speaker is fixed to “0000”.It can not

be paired with a bluetooth source device whose passcode is not “0000”.

Operation

Using By Connecting with Bluetooth Mobile phone

1. Press & Hold the Speaker Pairing Button for 8 seconds until the LED flashes red & blue.

Red & Blue

LED flash

2. Turn on bluetooth mode of Mobile phone and enter "Search Bluetooth device" mode.

3. Mobile phone will find a device name "NS-BT007." Select this device. Input passcode "0000."

Bluetooth Device: NS-BT007 Passcode:

BT 0 0 7

00 00

Selection

Cancel

OK Cancel

Remark: For other bluetooth source devices, passcode may be called”8888,” ”pass,” etc.

4. Mobile phone will ask "Authorize Auto Connect." Select YES.

Authorize Connect:

YES NO

5. After pairing is successful, the Speaker LED will flash blue.