- Digital Peripheral Solutions Speaker System User Manual
Operation
6. Start your music player from your mobile phone.
7. If your phone supports AVRCP, the main speaker button is able to control Play/Pause/Next
Previous Song.
8. If your phone supports A2DP, the speaker will produce a stereo sound effect.
9. You can adjust the speaker volume with the Bluetooth Mobile Phone supporting
AVRCP.
Remark:
Speaker will remain in pairing mode for 1 minute. If the pairing fails, please turn off the device and
restart steps 1 - 5.
For detailed information of your mobile phone A2DP & AVCRP function, please refer
to your mobile phone user guide.
To finish music
1. To turn off speaker, press and hold the speaker pairing button for 3
seconds
.
2. To turn off Bluetooth AV Dongle, press and hold the Dongle pairing button
for 3
seconds
.
3. Leave your mobile phone in Bluetooth mode.
Auto Connection
NS-BT007 is able to save the data that the device has been registered with. It can be saved
with
up to 8 different devices. Therefore, if the device has been registered with an Afloat
Speaker before, it will
be able reconnect automatically. However if the device fails to
reconnect automatically,
please follow the pairing instructions above.
Abou
t Vent
Hole
Precautions
About The Bluetooth Speaker System
1. Do not open the speaker. Refer repair service to qualified personnel only.
2. If you need to open the battery compartment while the speaker is wet, please use a dry
towel to dry the
speaker to keep water out of the battery compartment.
If you accidently wet the battery compartment, please use a dry towel to dry out the
battery compartment and let sit at room temperature for few hours before installing a
new battery.
Turn counter-clockwise to open the battery door
Turn clockwise to close the battery door
3. Since this speaker is waterproof, make sure the battery door is closed very tight to
prevent water from entering.
4. Please
do not put anything into the hole.
About Bluetooth Communication
Bluetooth technology operates within a range of about 33 feet. In fact, it may
The vent hole exists to stabilize speaker sound quality. Please
do
not put anything into
the hole. If water should go into the hole, do not worry -- it will
not affect the speaker quality. However, it would be best to leave the speaker
upside down for awhile to let the water drain out when you are not using the speaker.
9
be less
if there are obstacles (people, metal, walls, etc) or an electromagnetic
environment.
The following conditions may affect the sensitivity of Bluetooth communication:
*There is an obstacle, such as a person, metal or wall between NS-BT007 and
the
Bluetooth device.
*A device using 2.4GHz frequency, such as a wireless LAN device, cordless
telephone, or microwave oven, is in use near NS-BT007 may cause distortion and
result
in communication speed deterioration, noise, or invalid connections.
10