Remote Monitoring Guide

42 43
PICTURE 3-41
PICTURE 3-40
PICTURE 3-44
Schedule - This is exactly the same as the Schedule menu, allowing you to set up the
recording mode for each camera for specific times of the day.
Alarm - This submenu will only appear if the recorder has alarm capabilities and will have
three or four tabs depending on the type of recorder. This menu is for scheduling the
alarm periods and determining how the system will react when an alarm is triggered by
different types of alarm events. The IPC External Alarm will only appear when you are
logged into an NVR and handles any alarm inputs from cameras like the QCN8002B
and QCN8010Z.
The next two tabs cover signal loss and alarms triggered by external sensors connected to the
recorder. These tabs operate in the same manner as their respective menus on the recorder
with full information covering setup of events and triggers can be found in Sections 3.4
Recording and 6.3 Alarm Setup and Activation in the Users Manual. The Network
Alarms tab is for future software development and is not functional at this point in time.
Motion Events - This is the area where most users will make changes. This menu duplicates
the Events menu which is found in the Settings menu on the recorder. This is
covered in Motion, Video Loss and Camera Masking Detection which is
located in Section 3.4 Recording of the Users Manual.
PICTURE 3-42 PICTURE 3-43
The three tabs operate in the same manner, allowing you to choose what action the recorder
will take in the event that motion is detected, the video signal is lost or something blocks the
camera. Each tab has a similar set of options available to the user allowing you to have teh
recorder send email alerts, take snapshots, start recording on one or more cameras and etc.
Once you have made changes to the settings, click on the Save button. You may also copy
the settings made on one channel to another channel using the Copy button.