Technical Manual

32 33
MAIN MENU
SEARCH
INFO
ADVANCED BACKUPREMOTE DEVICE
SHUTDOWN
SETTING
RECORD SETTINGS
PICTURE 3-7
There are eight submenus available; Search,
Record Settings, Setting, Remote Device,
Advanced, Backup, Info, and Shutdown.
Clicking on an icon will take you to that
function or the submenu it represents.
MAIN MENU
After logging in, you can view – and access - the NVR’s functions through the Main Menu.
SHUTDOWN
Selecting the Shutdown icon in the Main Menu will open the Shut Down window.
This window allows you to choose to log out
as a user, shut down the system, restart the
system or switch users.
In addition, the NVR can also be shut down
by pressing on the front panel power button
for three seconds. The system will stop
operating and it can then be turned off via the
Power button on the rear of the NVR.
PICTURE 3-8
PICTURE 3-9
SHUTDOWN
Password is needed to re-enter the menu
after logout.
Logout menu user
OK Cancel
AUTO RESUME
In the event of a power failure, the NVR will automatically save any video files it is currently
recording and will then resume scheduled operations once power is restored.
PICTURE 3-10
3.4 RECORDING
Your NVR is factory set to record when motion is detected. Most users prefer this as it means
that it is easier to locate an event using the Search function (see Section 3.5) and it will take
longer before the DVR will need to overwrite older files on the hard drive. You can override
this in the Record menu, as discussed below, or you can schedule the hours when the NVR
captures motion.
MANUAL RECORDING
This window allows you to override the scheduled recording times of selected cameras. You
can access the Record Status menu via the Shortcut menu or by pushing the Record
button on the remote.
There are three status modes: Schedule, Manual and Stop. The status of each channel is
shown by the filled circle under its number. Each camera can only have one status at a time.
Changes take effect once the OK button is selected.
Manual – The selected cameras will begin recording
Schedule – Cameras record based on your settings made in the Schedule Menu or Detect
Menus (see following pages)
Stop – All selected cameras stop recording
These same settings can be applied
separately to the Extra Stream. This is the
video data that is sent by the NVR through
the Internet to enable remote monitoring.
This stream has a lower bandwidth than the
main stream which is recorded to the DVR.
Having a lower bandwidth makes it easier for
mobile devices to display the video feeds in
real-time.
RECORD STATUS
Record Mode All 1 2 3 4
Schedule
Manual
Stop
Schedule
Manual
Stop
OK Cancel
Extra Stream
You can assign the same values to all cameras by selecting the desired status in the “All”
column.