Remote Monitoring Guide

28 29
PICTURE 3-3
STEP 7. Uncheck the “Require server
verification (https:) for all sites in
this zone” button.
STEP 8. Type the NVR’s IP address
(obtained during Network Setup)
or DDNS domain name into the “Add
this website to the zone:” box.
STEP 9. Click the Add button
STEP 10. Close the window.
PICTURE 3-4
STEP 11. Click the Custom level…
button.
STEP 12. Pull down the “Reset to:”
menu button and select Low
PICTURE 3-6
STEP 13. Click the Reset button
STEP 14. Click “Yes” when asked, “Are
you sure you want to change the
setting for this zone?”
STEP 15. Click OK
STEP 16. Click Apply
STEP 17. Click OK
STEP 18. Close Internet Explorer
Open a browser window in Internet Explorer and enter the IP address or DDNS name
(obtained in Section 1.1) into the address bar.
PICTURE 3-7
You will see a log in screen similar to that
shown in Picture 3-7 or yellow alert bar at
the top of the window asking for permission
to open an ActiveX application. Allow it to
install webrec.cab control to reach the
sign-in screen.
Proceed to Section 3.2 Monitoring with
Internet Explorer for instructions on
logging in and remote monitoring.
PICTURE 3-5