Remote Monitoring Guide

28 29
STEP 12. Pull down the “Reset to:”
menu button and select Low
PICTURE 3-6
STEP 13. Click the Reset button
STEP 14. Click “Yes” when asked, “Are
you sure you want to change the
setting for this zone?”
STEP 15. Click OK
STEP 16. Click Apply
STEP 17. Click OK
STEP 18. Close Internet Explorer
PICTURE 3-5
3.2 USING WEB SERVICE
The instructions below show screen shots from Internet Explorer 10 on a Windows PC.
However, the Web Service looks and operates identically on different browsers. If a user
running Windows Vista or Windows 7 experiences difficulty with functionality, User Account
Control (UAC) may need to be disabled. UAC instructions are provided at the end of this
section under “Troubleshooting.”
STEP 1. - Enter the IP address or the DDNS address obtained in Section 1.5 into an
Internet Explorer window. You will see the Login screen shown in Picture 3-20
STEP 2. Enter the User Name and
Password in the appropriate fields.
The default user name and password
are admin and admin.
PICTURE 3-20
IMPORTANT! We strongly recommend that you modify your password on
the DVR itself for extra security before logging into it remotely as changing the
password from a PC will cause you to be logged out.
If you are logging in using a computer on the same local network as your system, you may
select the LAN button for a faster, clearer data stream. If your network is slow, or if you are not
on the same network as the NVR, then use the WAN option for better video speeds.
Other Considerations
• Internet Explorer 10 and 11 have ActiveX Filtering which may need to be turned off.
• On 64-bit Windows computers, Internet Explorer 10 and 11 may need to run in 32-bit mode.