Quick Installation Guide For the PTZ Dome Controller Remote control for PTZ and PT cameras 1
Thank You for Choosing a Q-See Product! All of our products are backed by a conditional service warranty covering all hardware for 12 months from the date of purchase. Additionally, our products also come with a free exchange policy that covers all manufacturing defects for one month from the date of purchase. Permanent upgrading service is provided for the software and is available at www.Q-See.com. Be certain to make the most of your warranty by completing the registration form online.
INTRODUCTION This quick-start guide is written for the QD6531Z and QD6505P speed dome cameras with remote control and was accurate at the time it was completed. However, because of our ongoing effort to constantly improve our products, additional features and functions may have been added since that time. We encourage you to visit our website at www.Q-See.com to check for the latest firmware updates and product announcements.
CONNECTING THE CONTROL MODULE It is recommended that you test your camera near your DVR before mounting it in order to ensure that proper connections have been made and that everything is operating normally. STEP 1. Connect the power/video/control extension cable to the camera according to the instructions in the camera’s manual. These are located in the section entitled “Connecting the Camera.” LED READOUT When the Control Module is powered up, it will display one of two messages - A001 or P001.
1.2 REMOTE CONTROL All of the commands and settings for your PTZ camera will be made using the remote that came with your camera. If you are connecting your camera to a DVR, the remote that came with that system will not work for controlling your camera.
To change address STEP 1. Press the CAM button until it shows the address number, A=001 STEP 2. If the desired channel is 1-9, simply push that number on the remote. For addresses 10-16, you will need to press the “-/--” button before entering the two digits. You may press the C button to delete a digit. ESC SETUP STEP 3. If you are entering a two-digit address, you will need toDISPpressPRESET EnterPATTERN after the second DELETE digit.
IRIS Going to a preset point Once you’ve set your preset points, you can use the remote to direct the camera to those spots. For preset points 1 through 8, you will only need to push the appropriate Shortcut button labeled P1 through P8 at the bottom of the remote. To point your camera at preset points 9 through 80, you will need to follow these steps: FOCUS- ZOOM- CLOSE S1 S2 S3 S4 F1 F2 F3 F4 P1 P2 P3 P4 P5 P6 P7 P8 STEP 1. Press the Shot button. STEP 2. Press press the “-/--” button.
APPENDIX TROUBLESHOOTING Symptom Cannot control camera. Solution Check that the RS485 wires are securely connected and in the proper ports. Check that settings for protocol, baude rate and address match those set within the camera. Focus, Iris and Zoom functions do not work. Iris and focus functions are handled automatically by the camera. The QD6505P camera does not have a zoom lens. Buttons F1 through F4 are non-functional. These buttons are focus shortcuts and are not supported by your camera.
Digital Peripheral Solutions, Inc. 8015 E.
