Technical Manual

ManualsBrandsQ-See ManualsCamerasQ-See QD6531Z

12 13

Going to a preset point

Once you’ve set your preset points, you can use

the remote to direct the camera to those spots.

For preset points 1 through 8, you will only need

to push the appropriate Shortcut button labeled

P1 through P8 at the bottom of the remote.

To point your camera at preset points 9 through

80, you will need to follow these steps:

STEP 1. Press the Shot button.

STEP 2. Press press the “-/--” button.

ESC

21 3

54 6

87 9

-/--C 0

DISP

RUN

SHOT CAM

SPEED AUTO

PRESET

HOME

SETUP

PATTERN

DELETE

OPEN

IRIS

FOCUS+

FOCUS-

ZOOM+

ZOOM-

ENTER

PICTURE 2-3

STEP 3. Enter the two-digit preset point number.

STEP 4. Press Enter.

The camera can be directed to the Home point by using the Home button located at the top of the

remote.

AUTO PAN

You can set up your camera to constantly move back and forth between two points. This action,

called an auto pan, can be useful in surveying a wider area than can be seen by a single camera, for

example. The two points can have different focus settings (if applicable).

STEP 1. Position the camera at the desired

starting point.

STEP 2. Press and hold the Preset button

for approximately 3 seconds until the

Set- message appears.

STEP 3. Press the A button at the top of the

remote. The message Lt-A will appear.

STEP 4. Repeat for the end point, using the

B button this time.

STEP 5. Press A to begin the pan.

Pressing B will cause the camera to pan in the opposite direction, skipping the area covered by the

other pan. Pressing any directional key will stop a pan cycle. Points A and B and be reset as needed.

PICTURE 2-4

SCAN

The scan pattern is simply a 360-degree horizontal rotation of the camera based on the position -

and zoom settings - of the Home point (see above.)

SURVEILLANCE PATTERN

You can create a surveillance pattern that will be recorded by the camera for it to follow. It does not

use any of the preset points you may have created, but rather copies the exact motions of the intial

pattern. This includes pauses at selected points. If, for example, your intial pattern includes a pause

for 10 seconds at a particular spot, the pattern will include a 10-second delay at that point. You may

have up to 16 points along the pattern. You do not have to end the pattern at the same position from

which you began as the camera will return to the starting point to repeat the pattern.

Setting a pattern

STEP 1. Press and hold the Pattern button until the LED display reads PstA

STEP 2. Create your surveillance pattern by directing your camera as desired.

STEP 3. When you have ﬁnished your pattern, press and hold the Pattern button again until the

LED display reads PstO

STEP 4. Press Enter to save your pattern.

Press the Run button to have your camera begin the surveillance pattern. The LED display will read

the PrUn message to indicate that it is running your pattern. You may override and interrupt the

pattern at any time by pressing a directional control, zoom or Preset shortcut button.

2.5 SPECIAL FUNCTIONS

There are several additional functions which are saved as presets and which can be accessed in the

same manner:

Press Shot

Press -/--

Enter function number

Press Enter

After you press Enter, the function will take place.

Preset Operation

Camera pans 360° before reversing and

panning 360° again

94 Clears all settings except presets

95 Clears all settings including presets