Technical Manual

POWRE
Monitor
UP DATA+
DATA
MENU
DOWN
Digital video Recoder Monitor
4
Dual
PAL NTSC
All keys can be used as password key except [ MENU]
key, which is used for confirming and exit.........................
5.11 Sub Menu-Picture Setup
POWRE
Monitor
UP DATA+
DATA
MENU
DOWN
Digital video Recoder Monitor
4
Dual
PAL NTSC
SATURATION 60
CONTRAST 80
BRIGHTNESS 50
SATURATION 60
CONTRAST 80
BRIGHTNESS 50
SATURATION 60
CONTRAST 80
BRIGHTNESS 50
SATURATION 60
CONTRAST 80
BRIGHTNESS 50
> >
> >
HUE : 0-99
SATURATION 0-99
CONTRAST 0-99
BRIGHTNESS 0-99
Button function:
[ UP][ DOWN]: move the prompt
[ REW]: Increase Value
[ FWD]: Reduce Value
[CH1~CH4,QUAD]: Select Channel
[ MENU]: exit.
5.12 Sub Menu-Time Setup
POWRE
Monitor
UP DATA+
DATA
MENU
DOWN
Digital video Recoder Monitor
4
Dual
PAL NTSC
PTZ SETUP
CHANNEL ADDRESS PROTOCOL BAUP RATE
1 1 PELCO-D 2400
2 2 PELCO-D 2400
3 3 PELCO-D 2400
4 4 PELCO-D 2400
(<.>) MOVE (<<.>>) AD JUST (MENU) EXIT
<
POWRE
Monitor
UP DATA+
DATA
MENU
DOWN
Digital video Recoder Monitor
4
Dual
PAL NTSC
TIME SETUP
2008/08/08 08:08:08
PRESS(UP,DOWN). THEN(SELECT)
PRESS(MENU) TO EXIT
>
Configure DVR system time. Press[ UP] and [ DOWN]
to move prompt and press [ SEL/EDIT] to modify. Press
[ MENU] to save and exit.............................................
5.13 Sub Menu-PTZ Setup
CHANNEL: Camera Number.
ADDRESS: Dome's address 0-255 .
PROTOCOL: Including PELCO-D PELCO-P
SAMSUNG BO1 NEON CTNCOM ,
Setting the protocol according to the dome's protocol.
BAUD RATE: Press [ SEL/EDIT] button to select the
value 1200 2400 4800 9600 19200 bps.
If you have a compatible speed dome camera attached to your DVR, press the
PTZ button and select the camera number that you wish to control. You can use
UP DOWN RIGHT and LEFT buttons to control the speed dome's
horizontal and vertical positioning. Press the REW , FWD , PAUSE , and
PLAY buttons to control the speed dome s ZOOM and FOCUS functions.............
.............
NOTE: Make sure all the lines are correctly connected to the speed dome, and
the proper protocol, baud rate, and address are set per its instructions.
8