Use and Care Manual

17
PICTURE 2-7
Changing Display Resolution
You can adjust the NVR to optimize its output
to best match the capabilities of your monitor
or HD display through the following steps:
STEP 1. Open the Basic window in the
Setup window which is located in the
Main Menu.
STEP 2. Click on the System tab.
STEP 3. Use the Video Output pull-down to
select your desired resolution.
STEP 4. Click on Apply to save your settings
and then click Exit.
STEP 5. Your system will restart. You will
have to re-log in afterwards.
STEP 1. Connect a BNC-to-RCA cable to the “Video Out” port on the back of the NVR.
STEP 2. Plug the RCA end into the “Video In” port on the television.
STEP 3. Plug the television’s power cable into a surge protector.
MULTIPLE MONITORS AND SPOT OUT
Some NVRs include a Spot Out BNC port on their back panel. This allows you to connect a
second video display that will show selected channels in sequence, but will not display the
menu and therefore cannot be used to control the NVR. This is covered in Section 4.2 Live
Configuration. Some users will want to take advantage of the unused video display outputs
(ie; using the BNC Video Out port when the VGA port is being used for the main display. This
“extra” display will mirror whatever is shown on the primary display but it will not show the
menu or cursor. It is not possible to divide channels across two displays.
Television
A third option for a video display is any television with an RCA video input. The NVR’s Video
Out port uses a BNC (British Naval Connector) type for coaxial cable. Depending on model,
your NVR may include a BNC-to-RCA cable or adapter. The latter converts the BNC jack to
an RCA port allowing you to connect the NVR to the television using a readily available RCA
cable.
PICTURE 2-6
SystemSystem Date & TimeDate & Time DSTDST
BASICBASIC
DefaultDefault
ApplyApply ExitExit
EDVR
0
NTSC
10
HDMI
English
5
EDVR
0
NTSC
10
HDMI
English
5
Device Name
Device ID
Video Format
Password Check
Show System Time
Max Online Users
Video Output
Language
Logout After [Minutes]
Startup Wizard
No Image When Logout
Device Name
Device ID
Video Format
Password Check
Show System Time
Max Online Users
Video Output
Language
Logout After [Minutes]
Startup Wizard
No Image When Logout