Use and Care Manual

21
NVR
POE
Block
POE
Block
NVR
POE
Block
POE
Block
Network
Network
Port
POE
Router
NVR
POE
Block
POE
Block
POE
Router/
Modem
POE
Router/
Modem
NetworkNetwork
Port
Internet
Internet
PICTURE 2-17
OVER THE INTERNET
This allows you to connect to cameras in a
completely different location.
• You will need to use the IP Tool (PC) or
the NVMS software (Mac) included on
the Manuals and Software CD or by
download from www.Q-See.com/support.
• Follow instructions in the IP Camera
Manual (also on the CD) to get the IP
address of the camera.
• Once you have the IP address of the
camera, you can add it to the NVR through
the following steps:
STEP 1. Connect the camera to a POE Injector, such as Q-See’s QAPE model.
STEP 2. Plug the injector into a power outlet.
STEP 3. Use a network cable to connect the injector to a network port.
OBTAIN IP ADDRESS:
STEP 4. Install the IP Tool sofware
onto a Windows PC connected to the
same network as the remote camera.
STEP 5. Launch the IP Tool sofware. It
will locate the camera and display its
information.
PICTURE 2-18
PICTURE 2-19
NOTE! The IP address shown
is only for your local network.
The NVR cannot use this to
connect to the camera over
the Internet.