Use and Care Manual

4.1 BASIC CONFIGURATION

This chapter is intended to help you get your NVR up and running before you activate any

advanced features which are covered in later chapters. You can use the mouse, remote

control and the buttons on the front of the NVR to operate your system, but for convenience,

we will be discussing operations using the mouse. Information on P.T.Z. cameras and alarms

will be found in their own chapters, Chapters 7 and 8, respectively.

MENU NAVIGATION

Navigation through the user interface is point and click. Double-clicking on an icon within a

given menu will open that menu, or a submenu. The Main Menu is the starting point to reach

all of the NVR’s settings and features. Selecting the Menu icon on the left of the Control Bar

or pressing the Menu button on the NVR and remote control open the Main Menu.

MAIN MENU SETUP

CHAPTER 4

PICTURE 4-2

PICTURE 4-1

Clicking on any icon will open the relevant

menu.

SETUP

From the Setup menu select the Basic menu

by clicking on its icon.

PICTURE 4-3

Main Menu

NOTE! When conﬁguring your settings, you will always need to click Apply to save your

current settings before closing the window with Exit otherwise your changes will be lost.

You may click Exit or the close window box (X) in the upper right of the window to close

without saving changes but an alert will pop up asking if you wish to save changes. Click

OK to save changes or Cancel to continue without saving. You may select the Default

button to restore your settings to those set at the factory.