User manual

133
iSCSI Quick Configuration Wizard
The description below applies to non Intel-based NAS models running firmware version 3.3.0 or la te r
and Intel-based NAS models running firmware version 3.2.0 or la te r only.
A maximum of 256 iSCSI targets and LUNs can be created. For example, if you create 100 targets on
the NAS, the maximum number of LUNs you can create is 156. Multiple LUNs can be created for each
target. However, the maximum number of concurrent connections to the iSCSI targets supported by
the NAS varies depending on the network infrastructure and the application performance. Too many
concurrent connections may slow down the performance of the NAS.
Follow the steps below to configure the iSCSI target service on the NAS.
1. Under the “Portal Management” tab enable iSCSI target service. Apply the settings.
2. Go to the “Target Management” tab and create iSCSI targets on the NAS. If you have not created
any iSCSI targets, the Quick Installation Wizard will show up and prompt you to create iSCSI
targets and LUN (Logical unit number). Click “OK”.