User manual

58
To use this function, select the option “Enable IPv6” and click “Apply”. The NAS will restart. After the
system restarts, login the IPv6 page again. The settings of the IPv6 interface will be shown. Click the
Edit button to edit the settings.
IPv 6 A uto Config ura tio n
If an IPv6 enabled router is available on the network, select this option to allow the NAS to acquire the
IPv6 address and the configurations automatically.
Use s ta tic IP a ddre s s
To use a static IP address, enter the IP address (e.g. 2001:bc95:1234:5678), prefix length (e.g. 64),
and the gateway address for the NAS. You may contact your ISP for the information of the prefix and
the prefix length.
Enable Router Advertisement Daemon (radvd)
To configure the NAS as an IPv6 host and distribute IPv6 addresses to the local clients which
support IPv6, enable this option and enter the prefix and prefix length.
IPv 6 DNS s e rv e r
Enter the preferred DNS server in the upper field and the alternate DNS server in the lower field.
Contact the ISP or network administrator for the information. If IPv6 auto configuration is selected,
leave the fields as “::”.