User manual

613
Standalone mode - USB
To operate under USB standalone mode, follow the steps below:
1. Plug in the USB cable on the UPS to the NAS.
2. Select the option “Enable UPS Support”.
3. Choose between whether the NAS will shut down or enter auto-protection mode after AC power
fails. Specify the time in minutes that the NAS should wait before executing the option you have
selected. After the NAS enters auto-protection mode, the NAS resumes the previous operation
status when the power restores.
4. Click “Apply” to confirm.
Standalone mode - SNMP
To operate under SNMP standalone mode, follow the steps below:
1. Make sure the NAS is connected to the same physical network as the SNMP-based UPS.
2. Select the option “Enable UPS Support”.
3. Choose between whether the NAS will shut down or enter auto-protection mode after AC power
fails. Specify the time in minutes that the NAS should wait before executing the option you have
selected. After the NAS enters auto-protection mode, the NAS resumes the previous operation
status when the power restores.
4. Select “SNMP” from the “Protocol” drop down menu.
5. Enter the IP address of the SNMP-based UPS.
6. Click “Apply” to confirm.